[. . . ] A mounting suitable for outdoor use and rated for wet locations is required. Follow all applicable electrical codes and regulations. WARNING: Electric shock hazard WARNING: Fire hazard Disconnect power at circuit breaker or fuse box before installing or servicing light. [. . . ] Connect the selected voltage fixture wire to the Black (hot) cord wire. Connect the white fixture wire marked "COM" to the White (neutral) cord wire. Connect the Green (equipment ground) cord wire to the fixture ground screw. Install the fixture to the Trunion Mounting Bracket using the (2) Trunion Bolts. On the trunion assembly there are (3) position holes in the outer yoke and (5) positioning hoes in the inner yoke. Align the positioning holes as desired and secure with Positioning Screw. Using approved twist on wire connector, connect the free end of the 4ft cord to the supply wires inside an approved outdoor, watertight junction box. Connect the White (neutral) cord wire to the White (neutral) supply wire. Connect the Green (equipment ground) cord wire to the Green (equipment ground) supply wire. To weatherproof fixture, seal all holes in housing (mounting conduit, plugs, photocontrols, etc. ) with silicone sealant. [. . . ] Remove old lamp and replace with new lamp of correct type and wattage. Install, close, and secure lens cover with (2) screws making sure that gasket is properly seated, free of debris, and compressed to seal out moisture. [. . . ]